Cleaning And Washing - NSK prophy-mate neo Bedienungsanleitung

Use the blower nozzle in the same way to clear the
lines in the Prophy-Mate neo nozzle. Blow from the
far end of the nozzle.
CAUTION
When performing idle running hold
components tightly.

4-3 Cleaning and washing

1) Carefully clean the inside of the joint section of the
handpiece and the O-ring section of the powder
case with the attached cleaning brush. (Fig. 11)
If powder adheres to the O-ring section, remove
the O-rings, and carefully clean the O-rings and
grooves. (Fig. 12)
2) Remove the rubber packing and disassemble the
powder case cap. (Fig. 13)
Blower nozzle
Rubber packing
10
Nozzle
Fig. 10
Fig.11
Fig.12
Fig. 13