Switching Link; Post-Use Maintenance; Preparation For Maintenance; Cleaning And Disinfection - NSK Wireless Link Tool Link Module LMP2 Bedienungsanleitung

Right button
Select a Burst Output Level
Speed control pedal
Vibrate the tip at the set power while the pedal is depressed.
• Changing the settings of the foot control buttons of Surgic Pro2 is enabled only when
operating Surgic Pro2.
• When the Surgic Pro2 displays "LINK", key operations other than the LINK key and
Cancel key are disabled.
5–3 Switching link
Press and hold the LINK key of the Surgic Pro2 for more than 2 seconds to switch the link
connection.
Press and hold the Cancel key of Surgic Pro2 for more than 2 seconds to return to the
operation of Surgic Pro2.
8
CAUTION
NOTICE

Post-use Maintenance

6
6–1 Preparation for maintenance
1 Wear eye protection, a mask, and gloves
to prevent infection.
6–2 Cleaning and disinfection
1 Wipe the surface of the products with
a cloth moistened with ethanol for
disinfection.
• Do not clean, immerse, or wipe with electrolyzed-oxidizing water (strong acidic
water, super acidic water), strong acidic and strong alkaline liquid solution, solvent
containing chlorine, benzene or thinner.
• Follow any additional local directives, standards, and guidelines for cleaning,
disinfection and sterilization.
• For maintenance of the Surgic Pro2 and the VarioSurg 3, refer to the operation
manual for each product.
• Use ethanol for disinfection that complies with the regulations of each country.
2 Turn off the power switch of the
VarioSurg 3 control unit.
2 Store the products in a place where they
can be kept clean and dry until used
next time.
CAUTION