Minimising Wear And Preventing Damage; Standard Spare Parts; Ce - Manufacturer's Declaration Of Conformity - Viking ME 339 Gebrauchsanleitung

The machine, its packaging and
accessories are all produced from
recyclable materials and must be disposed
of accordingly.
By disposing of materials separately, and
in an environmentally friendly manner,
valuable resources can be re-used. For
this reason, the machine should be
disposed of for recycling at the end of its
useful life. Pay particular attention to the
information in the "Disposal" section
during disposal ( 4.7).
Consult your recycling centre or your
specialist dealer for information on the
proper disposal of waste products.
15. Minimising wear and
preventing damage
Please always observe the following
important information for the prevention of
damage or excessive wear to your VIKING
machine:
1. Wearing parts
Some parts of the VIKING machine are
subject to normal wear even when used
properly and must be replaced in due time
depending on type and duration of use.
These include:
– Blade
– Grass catcher box
2. Compliance with the information in
this instruction manual
The VIKING machine must be used,
maintained and stored with the care
described in this instruction manual. Any
damage caused by non-compliance with
the safety, operating and maintenance
instructions is the sole responsibility of the
user.
40
This applies in particular to:
– inadequately dimensioned power
cables (cross section),
– incorrect electrical connection
(voltage),
– product modifications not approved by
VIKING,
– the use of tools or accessories which
are not approved or suitable for the
machine, or are of inferior quality,
– improper use of the product,
– use of the product for sporting or
competitive events,
– resultant damage due to continued use
of the product with defective
components.
3. Maintenance operations
All operations listed in the section
"Maintenance" must be performed
regularly.
If these maintenance operations cannot be
carried out by the user, a specialist dealer
must be commissioned to perform them.
VIKING recommends that you have
maintenance operations and repairs
performed exclusively by a VIKING
specialist dealer.
VIKING specialist dealers regularly attend
training courses and are provided with
technical information.
If these operations are neglected, faults
may arise which are the responsibility of
the user.
These include:
– damage to the drive motor as a result of
inadequate cleaning of the cooling air
guide (inlet slots),
– corrosive and other resultant damage
caused by incorrect storage,
– damage to the machine through the use
of inferior-quality spare parts,
– damage due to untimely or inadequate
maintenance or damage due to
maintenance or repair work not
performed in the workshops of
specialist dealers.

16. Standard spare parts

Mowing blade
6320 702 0100
Blade fastening screw
6310 710 2800
The fastening elements for the
mowing blade (e.g. blade fastening
screw) must be replaced when
replacing the blade, i.e. when
installing the blade. Spare parts are
available from a VIKING specialist
dealer.
17. CE - manufacturer's
declaration of conformity
We,
VIKING GmbH
Hans Peter Stihl-Strasse 5
A 6336 Langkampfen/Kufstein
declare that the machine,
Lawn mower, manually-operated and
mains-powered (ME)
manufacturer's VIKING
brand:
Type: ME 339.0
0478 121 9917 E - EN