Replacing The Ej - Olivetti CFR3000 Anwenderhandbuch

REPLACING THE EJ

When the EJ is full, the cash register sends the user a notification message. The
user must see to replacing the card with a new one, and archiving the old card.
To replace the card, proceed as follows:
1. Power off the cash register and disconnect it from the 220V electrical socket.
Wait for about 20 seconds.
WARNING: SD memory cards commonly found on the market cannot be used in
the cash register, but only cards supplied specifically by Olivetti
Authorised Centres.
2. Open the hatch (1) and push the card inwards to eject it (2).
3. Insert the new EJ card into the slot (2) so that it clicks into place. Close the hatch.
4. Insert the power plug into the 220V electrical socket and power on the cash
register using the On/Off key. Follow the instructions given in the chapter
"Initialising the Electronic Journal").
1
2
2
10-5