Deleting The Ej - Code 459 - Olivetti CFR3000 Anwenderhandbuch

DELETING THE EJ – CODE 459
To be able to reuse an SD-type memory device on which an electronic journal
has previously been registered, first of all its contents must be deleted and
then the card must be initialised.
In order to start the deletion procedure, an SD-type memory device that has
already been used must be loaded inside the cash register; in this case, proceed
as follows:
1. Press [Config] in the [F] (Function) > GENERAL FUNCTION environment >
[Set setup] :
2. Using the numeric keypad, enter the code 4 5 9 followed by X .
3. Start the DELETION procedure by touching the X . key on the touch screen.
Warning: executing the delete operation on the SD-type memory device
destroys all the data it contains therefore, afterwards, this data will no
longer be readable.
Note: Pressing the Delete key on the touch screen cancels the DELETION
procedure).
4. The message below is displayed on the touch screen.
5. The memory device has been deleted correctly. Open the door of the bay
containing the EJ card. A message is displayed on the screen notifying that the
door is open.
F
03.03.2012 18.10 Till No.: 1
Vch: ON Pr.list 1 Operator: Disabled
JOURNAL DELETED
OPEN COVER
10-7