Remote Control Ir; Dmx Operation - EuroLite LED IP PAR Bedienungsanleitung

Remote control IR-7

The device must be activated for remote control. For this, set menu item InFr to on. When actuating a
button, always direct the remote control towards the sensor. There must be no obstacles between remote
control and the sensor.
Notes:
• The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
• If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the
right and at the same time remove the battery support. For operation, one 3 V
button cell type CR 2025 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
• Remove the battery from the remote control as a precaution if the device is not used for a longer period of
time.

DMX operation

Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 8 control channels.
However, it can also be switched to a mode with 2, 3, 4 or 4-1 channels if different functions are required. To
be able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller's documentation.
1 Press the MENU button so many times until DMX is indicated in the display. Confirm with the ENTER
button.
2 The display indicates 2 CH (2 DMX channels), 3 CH (3 DMX channels), 4 CH (4 DMX channels), 4-1 CH
(4-1 DMX channels) or 8 CH (8 DMX channels). Use the buttons UP and DOWN to select the desired
number of DMX channels. Confirm with the ENTER button.
3 Now the display indicates the menu item for the DMX start address d***. Use the buttons UP and DOWN
to set the address. Confirm with the ENTER button.
4 A dot will light up when DMX signals are being received. If no control signals are available, the display
will flash.
Button Function
BLACKOUT
LEDs off
AUTO Automatic mode; program selection with (+)/(‒)
Strobe effect for automatic mode and sound control;
STROBE
flash rate setting with (+)/(‒)
SPEED Running speed in
DMX
DMX mode
Color mode; select colors with R/G/B/W;
MANUAL
setting with (+)/(‒)
Color fade mode, press the FADE key again to turn
FADE
off the FADE function, use
program speed
1-9
Total brightness; 1 = dark, 9 = bright
23/28
automatic mode; setting with (+)/(‒)
(+)/(‒) to set the FADE
00117372, Version 1.0