EuroLite LED IP PAR Bedienungsanleitung Seite 22

Automatic mode
In automatic mode, 2 show programs are available that run at an adjustable speed.
1 Press the MENU button so many times until AUTO is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to select the desired show program. Confirm with the ENTER
button.
2 Press the MENU button so many times until SPEED is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to adjust the running speed of the program from SP 01 (slow) to
SP 09 (fast). Confirm with the ENTER button.
Color mix
In COLOR mode each of the 4 colors can be individually adjusted in intensity. The device will then constantly
emit the chosen color setting.
1 Press the MENU so many times until COLOR is indicated in the display. Confirm with the ENTER button.
2 Now the display indicates the letter R for the color and the corresponding brightness value. Use the
buttons UP and DOWN to adjust the desired brightness.
3 Confirm with the ENTER button. Now the color green can be set; then blue and white until the desired
color intensity is achieved.
Total brightness
The menu point DIMMING allows adjusting the total brightness for all stand-alone operating modes: STATIC,
AUTO and COLOR.
1 Press the MENU button so many times until DIMMING is indicated in the display. Confirm with the
ENTER button.
2 Use the buttons UP and DOWN to adjust the desired brightness (dI 01 = dark, dI 09 = bright). Confirm
with the ENTER button.
Fading program
In FADING mode the speed for fading can be set.
1 Press the MENU button so many times until FADING is indicated in the display Confirm with the ENTER
button.
2 Use the buttons UP and DOWN to adjust the desired speed (00-99). Confirm with the ENTER button.
Strobe effect
In FLASH mode the speed for strobe effect can be set.
1 Press the MENU button so many times until FLASH is indicated in the display Confirm with the ENTER
button.
2 Use the buttons UP and DOWN to adjust the desired speed (00-99). Confirm with the ENTER button.
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLAVE is indicated in the display. Confirm with the ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Set the master unit to the desired operating mode. The interconnected devices will now operate in sync.
22/28 00117372, Version 1.0