Eurolite Ir-7 Remote Control; Cleaning And Maintenance; Replacing The Fuse - EuroLite LED KRF-140 Bedienungsanleitung

EUROLITE IR-7 remote control

Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and should
No. Key Function
1 BLACKOUT
2 STROBE
3 SPEED
4 SENSITIVITY
5 AUTO
6 SOUND
7 MANUAL

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
1
The device must be activated for remote control. For this, under menu
item InFr, press ENTER button to confirm activation.
2
When actuating a button, always hold the remote control in the direction
of the sensor. There must be visual connection between the remote
control and the sensor.
3
The remote control is supplied with a battery inserted. An insulating foil
between the battery and the battery contacts prevents the battery from
being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control.
Otherwise operation of the remote control is
not possible.
4
If the range of the remote control decreases
(10 meters as a maximum), replace the
battery. For this purpose, on the rear side of the remote control press
the small bar with the groove to the right and at the same time remove
the battery support. For operation, one 3 V button cell type CR 2025 is
required. When inserting, pay attention that the positive pole of the
button cell shows upwards in the support.
CAUTION!
not be disposed of with regular domestic waste!
Step 1 Step 2
BLACKOUT any button
STROBE +/-
SPEED +/-
SENSITIVITY +/-
AUTO +/-
SOUND +/-
MANUAL
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
Step 3 Description
Blackout
Strobe effect - available for the buttons
AUTO/SOUND/FADE/MANUAL/R/G/B/A/UV/W/0 - 9
Select the desired speed
Internal programs
Microphone sensitivity
Sound controlled mode
Internal programms
Sound controlled mode
R/G/B/A
18/19 00091586.DOC, Version 1.0