Remote Control Ir-7 - EuroLite LED CBB-2 Bedienungsanleitung

Strobe effect
In FLAS mode the speed for strobe effect can be set.
1 Press the MENU button so many times until FLAS is indicated in the display Confirm with the ENTER
button.
2 Use the buttons UP and DOWN to adjust the desired speed (00-99). Confirm with the ENTER button.
Behavior at missing DMX-signal
In DMX lost mode the program offers different options when no DMX signal is received.
1 Press the MENU button repeatedly until the display shows the DMX lost menu. Press ENTER to
confirm.
2
Select the desired program with the UP and DOWN buttons (see menu structure). Confirm with ENTER.
Potentiometer
If you select "on" in the PotE menu item, the brightness and color temperature rotary knobs are activated.
When set to "oFF", they are disabled.
Quick access via rotary knob:
The brightness and color temperature can be controlled via the rotary knobs on the back of the device (see
device overview), thus providing quick access to the static settings.
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLAV is indicated on the display. Confirm with the ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Set the master unit to the desired operating mode. The interconnected devices will now operate
synchronously.

Remote control IR-7

The device must be activated for remote control. For this, set menu item InFr to on. When actuating a
button, always direct the remote control towards the sensor. There must be no obstacles between remote
control and the sensor.
Button Function
BLACKOUT
LEDs off
AUTO Automatic mode; program selection with (+)/(‒)
SOUND Sound control; program selection with (+)/(‒)
Strobe effect for automatic mode and sound control;
STROBE
flash rate setting with (+)/(‒)
Running speed in
SPEED
with (+)/(‒)
SENSITIVITY Microphone sensitivity; setting with (+)/(‒)
DMX/%
DMX mode
Color mode; white color with W and 0 for warm white
MANUAL
color
Color fade mode, press the FADE key again to turn off
FADE/UNIT the FADE function, use (+)(-) to set the FADE program
speed
1-9 Total brightness; 1 = dark, 9 = bright
27/32
automatic mode and sound; setting
00131545, Version 1.0