Description Of The Device; Installation - EuroLite LED IP PAR Bedienungsanleitung

DESCRIPTION OF THE DEVICE

(1) Diffuser disc mounting screws
(2) Infrared sensor for the remote control
(3) 8 W RGBW LEDs
(4) Fixation screw
(5) DMX input
(6) LCD display and operating buttons

INSTALLATION

WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure
that the device is installed securely and cannot fall down. The installation must be carried out by
a specialist who is familiar with the hazards and the relevant regulations.
The device may be placed on the floor by unfolding the brackets or fastened to a truss or similar rigging
structure. The device must never be fixed swinging freely in the room.
1 The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2 Block access below the work area and work from a stable platform when installing the device.
3 Use rigging hardware that is compatible with the structure and capable of bearing the weight of the
device. Please refer to the "Accessories" section for a list of suitable rigging hardware.
4 Secure the device with a safety bond or other secondary attachment. This secondary safety attachment
must be sufficiently dimensioned in accordance with the latest industrial safety regulations and
constructed in a way that no part of the installation can fall down if the main attachment fails. Pull the
safety bond through the safety eyelet and fasten it in such a way that, in the event of a fall, the maximum
drop distance of the device will not exceed 20 cm.
(7) DMX output
(8) Power input
(9) Safety rope
(10) Power feed-through output
(11) Pressure compensation plug
(12) Mounting bracket
19/28 00117372, Version 1.0