9.1 Dust container
11
14
5
• Remove by pressing the unlocking
mechanism 14 at the suction device
and remove the dust container 11.
9.2 Paper filter (HEPA)
The paper filter 7 is located at the upper end
of the filter carrier 8.
• Release the paper filter 7 with a slight
twist before pulling it off.
7
8
• Hook the dust con-
tainer 11 on at the
bottom of the suction
device 5. Then press
it down at the top un-
til it engages.
• When inserting the
filter, ensure the posi-
tion of the small later-
al pins at the paper
filter 7. They must fit
into the openings of
the filter carrier 8.
Then, lock the paper
filter 7 again.
9.3 Metal filter
8
12
• To release, rotate the metal filter 12 in
the direction of the open lock symbol
• When assembling, rotate the metal fil-
ter 12 in the direction of the closed lock
symbol . Ensure that the metal filter 12
clicks firmly into place.
9.4 Motor protection filter
5
13
9.5 Exhaust air filter
3
2
4
The metal filter 12 is lo-
cated at the end of the
filter carrier 8. With a
slight twist, the metal fil-
ter 12 can be released
and put on again.
Between dust contain-
er 11 and suction de-
vice 5 the motor
protection filter 13 is lo-
cated.
• Remove the dust con-
tainer 11 from the
suction device 5.
Then, you can re-
move the motor pro-
tection filter 13 from
the inside of the suc-
tion device 5.
There are two exhaust
air filters 2 at the sides
of the suction device 5.
• To remove the filters,
press the unlocking
mechanism 3 at the
filter cover 4. Then,
you can remove the
exhaust air filter 2
from the filter cov-
er 4.
GB
.
11