Setting A Programme; Cancelling The Delay Start - Electrolux WAGL5T300 Benutzerinformation

20 www.electrolux.com
• Position A for powder detergent (factory setting).
• Position B for liquid detergent.
When you use the liquid detergent:
• Do not use gelatinous or thick liquid detergents.
• Do not put more liquid then the maximum level.

10.5 Setting a programme

1. Turn the programme knob. The
related programme indicator comes
on.
The indicator of button Start/Pause
flashes with red colour.
The display shows the default
temperature, the spin speed and the
empty indicator bars of the available
functions.
2. To change the temperature and/or
the spin speed, press the related
buttons.
3. Set the available functions.
10.6 Starting a programme
without the delay start
Press button Start/Pause to start the
programme.
The relevant indicator stops to flash and
stays on.
On the display the indicator of the phase
is operation starts to flash.
The programme starts, the lid is locked.
The display show the indicator
The drain pump can operate
for a short time when the
appliance fills water.
10.7 Cycle time recalculation
After approximately 15
minutes from the start of the
programme:
• The appliance adjusts
• The display shows the
automatically the cycle
time to the laundry you
have put in the drum to
have perfect washing
results in the minimum
necessary time.
new time value.
10.8 Starting a programme with
the delay start
1. Press button Delay Start again and
again until the display shows the
number of minutes or hours of delay.
The related indicator comes on.
2. Press button Start/Pause.
The appliance starts the countdown of
the delay start.
When the countdown is completed, the
programme starts automatically.
Before you press button
Start/Pause to start the
appliance, you can cancel or
change the set of the delay
start.

10.9 Cancelling the delay start

To cancel the delay start:
1. Press button Start/Pause to set the
appliance to pause.
The related indicator flashes.
2. Press button Delay Start repeatedly
.
until the display shows .
3. Press button Start/Pause again to
start the programme immediately.
10.10 Interrupting a programme
and changing a option
You can change only some options
before they operate.
1. Press button Start/Pause.
The related indicator flashes.
2. Change the option set.
3. Press the button Start/Pause again.
The programme continues.