Cancelling The Delay Start; Opening The Door; End Of Cycle - Electrolux WASL2E202 Benutzerhandbuch

20 www.electrolux.com

10.9 Cancelling the delay start

To cancel the delay start:
1. Press button Start/Pause - Départ/
Pause to set the appliance to pause.
The related indicator flashes.
2. Press button Zeitvorwahl - Départ
Différé repeatedly until the display
shows .
3. Press button Start/Pause - Départ/
Pause again to start the programme
immediately.
10.10 Behaviour of the
appliance
After approximately 15
minutes from the start of the
programme:
• The appliance adjusts
• The display shows the
10.11 Cancelling a running
programme
1. Press button Auto Off to cancel the
programme and to deactivate the
appliance.
2. Press button Auto Off again to
activate the appliance.
Now, you can set a new washing
programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
10.12 Interrupting a programme
and changing a function
You can change only some options before
they operate.
automatically the cycle
time to the laundry you
have put in the drum to
have perfect washing
results in the minimum
necessary time.
new time value.
1. Press button Start/Pause - Départ/
Pause.
The related indicator flashes.
2. Change the function set.
3. Press the button Start/Pause -
Départ/Pause again.
The programme continues.

10.13 Opening the door

If the temperature and level of
the water in the drum are too
high and the drum still rotates
you cannot open the door.
While a programme or the delay start
operates, the appliance door is locked.
1. Press button Start/Pause - Départ/
Pause.
In the display the related door lock
indicator goes off.
2. Open the appliance door.
3. Close the door and press button
Start/Pause - Départ/Pause.
The programme or the delay start
continues.

10.14 End of cycle

When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display comes on and the door
locked indicator
The indicator of Start/Pause - Départ/
Pause button goes off.
1. Press button Auto Off to deactivate
the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last set
programme. Turn the
programme knob to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent mildew
and odours
goes off.