Safety Instructions; Personal Safety - Ferm MSM1035 Betriebsanleitung

14. Bevel angle
15. Handle
16. Cover
17. Saw blade bolt
18. Flange
19. Screw
20. Screw retraction arm
21. Extension pieces (left and right)
22. Lock-button saw blade
23. Angle indicator
24. Support bracket

2. Safety instructions

By using electric tools basic safety precautions
should always be followed to reduce the risk of
fire. Electrical shock and personal injury.
Always read the specific product instruction
manual and the safety instructions before
attempting to operate the power tool and store
these instructions.
Install of a stationary machine.
Fig. 5
This machine is a stationary machine and for
safety reasons must always be firmly installed and
not used for mobile applications.
You can install the machine in two ways:
a) As a stationary machine on a workbench.
In case the machine must be secured to the
workbench with 4 bolts
b) As a stationary machine on a sub frame. In
this case the machine must be secured to
the sub frame with 4 bolts and the sub frame
anchored with 4 bolts to the floor plate with
dimensions of at least 1 square meter
Symbols
The following symbols are important for the
operations of your power tool. The correct
interpretations of the symbols helps you operate
the power tool more save
Denotes risk of personal injury, loss of
life or damage to the tool in case of
nonobservance of the instruction in this
manual
Caution, risk of electric shock
Keep bystanders away
Wear eye protection
Wear ear protectors. Exposure to noise
can cause hearing loss.
Wear a dust mask
Danger Area! Keep hands far away
(10cm) from the cutting area while the
machine is running. Danger of injury
when coming in conatct with the saw
blade
Do not direct the laser beam at persons
or animals and do not stare into the laser
beam yourself, not even from a distance.
This power tool produced laser class 2
laser radiation according to EN 60825-
1. This lead can lead to person being
blinded
Disc dimensions. Observe the
dimensions of the saw blade. The hole
diameter must match the tool spindle
without play. *Use only a fill ring which is
specified by supplier, filling ring may not
have any play
Tranport the machine only when the
machine is in inward transport position
1. Work area safety
a) Keep work area clean and well lit. Cluttered or
dark areas invite accidents
b) Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or
fumes
c) Keep children and bystanders far away while
operation a power tool. Distractions can
cause you to lose control, or material can shut
away
d) Never leave the machine unattended without
first disconnecting it from the mains voltage

2. Personal safety

a) If you are not familiar with using such
machine. You would be better to be informed
first by a professional, an instructor or by a
EN
5