Ferm MSM1035 Betriebsanleitung Seite 6

EN
technician
b) Store idle power tools out of the reach of
children. Power tools are dangerous in the
hands of untrained users
c) Keep power tools dry, clean and free from oil
and grease. Properly maintained power tools
are safer and easier to control. Grease oil
handles are slippery causing loss of control
d) Make sure you always have a clean and tidy
working environment. You could slip or trip
e) Stay alert, watch what you are doing and use
common sense when operating a power tool
f) Do not overreach. Keep proper footing and
balanced at all the time. This enables better
control of the power tool in unexpected
situations
g) Do not work with a machine while you under
the influence of alcohol, drugs or medication.
Inattention while operating power tools may
result in very dangerous injury
h) Use always protective equipment. Always
wear eye protection, dust mask, hearing
protectors and safety shoes. By service on
machine or raw materials use gloves. Keep
your hair back. Reduce changes on personal
injury
i) Be careful when sawing double miter joints.
Saw blade, Work piece and your hands must
be always visible during sawing
j) Never saw more than one piece of work at the
same time
k) Make sure that the piece of work not have any
nails/ staples or other foreign objects in it
l) Never process metal or stone with this
machine
m) Do not work with material containing asbestos
3. Power tool safety
The first time that the machine is used and then
every subsequent time that it is used:
Before carrying out any work on the
machine, disconnect the mains plug from
the power supply.
General: Check the entire saw machine. If any
part of the machine is missing, bent, damaged
or is dysfunctional in any other way, or if any
mechanical and/or electrical faults occur or are
visible, or if the machine makes any extremely
loud noises, refer to the user manual.
If any defects are detected on the machine, they
6
must all be rectified before the machine is used.
Only original parts should be used!
If you have any outstanding concerns which
could affect your own safety or the safety of the
machine, please consult the machine supplier.
Electrical
a) Always use an Original power plug which
matches the outlet, do not use an adapter
plug with earthed (grounded) power tools.
Unmodified plugs and matching outlets will
reduce risk of electrical shock
b) Do not use the machine with a damaged
power cable. Do not touch the damaged cable
and pull the mains plug when the cable is
damaged while working. Damaged cables
increase the risk of an electrical shock
c) Check the cable regularly and have a
damaged cable repaired. Replacing cables
or plugs. Immediately throw away old cables
or plugs when they have been replaced by
new ones. It is dangerous to insert the plug of
a loose cable in the wall outlet. Use original
power cord and plugs, repairing only through
an authorized person, this will ensure that the
safety of the power tool is maintained!
d) To prevent electrical shocks. When plugging
the plug into the socket the metal pins must
not be touched in any way whatsoever
e) Do not expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electrical shock
f) Never use the cord to pull the plug out of the
socket. Keep the cord and plug away from oil,
heat and sharp objects
g) When operating a power tool outdoors, use
an extension cord suitable for outdoor use.
Use a cord for outdoor use reduces the risk of
electric shock
h) When machine is equipped with laser. Do
not direct the laser beam at persons or
animals and do not stare into the laser beam
yourself. Not even in distance. Laser must be
according to EN 60825-1 Class 2.
i) Repairs of a laser may only be carried out by
the laser manufacture or a specialist
j) If operating a power tool in a damp location
is unavoidable, use a residual current device
(RCD) protected supply. Use of an RCD
reduces the risk of electric shock
Mechanical
a) Before you start the machine, check if the