Werbung
DK
76
5.
Auxiliary handle
6.
Tool holder
7.
Chisel
8.
Oil gauge
2. SAFETY INSTRUCTIONS
In this operator's guide the following symbols are used:
Read instructions carefully
In accordance with essential applicable safety standards of European directi-
ves
Denotes risk of personal injury, loss of life or damage to the tool in case of
non-observance of the instructions in this manual.
Indicates electrical shock hazard.
Immediately unplug the plug from the mains electricity in the case that the cord
gets damaged and during maintenance
Wear ear and eye protection
Faulty and/or discarded electrical or electronic apparatus have to be collected
at the appropriate recycling locations.
Special safety instructions
•
Wear a hard safety helmet, safety glasses and/or face shield. It is also highly recom-
mended that you wear a dust mask, ear protectors and thickly padded gloves.
•
Be sure the bit is secured in place before operation.
•
Under normal operation, the tool is designed to produce vibration. Check tightness of
screws carefully before operation to avoid a breakdown or accident.
•
In cold weather or when the tool has not been used for a long time, let the tool warm
up for several minutes by operating it under no load. This will loosen up the lubrica-
tion. Without proper warm-up hammering operation is difficult.
•
Always be sure you have firm footing. Be sure no one is below when using the tool in
high locations.
•
Hold the tool firmly with both hands.
•
Keep hands away from moving parts.
•
Do not point the tool at any one in the area when operating. The bit could fly out and
injure someone seriously.
Ferm
Ferm
GB
05
Quicklinks ausblenden:
Werbung
Kapitel
