Repair; Taking Out Of Service; Information For Energy Saving - Franke Frames FS 913 M Bedienungsanleitung

EN

Repair

Do not allow anyone except qualified personnel to
Z X
install or repair the appliance.
Contact a service centre authorised by the
Z X
manufacturer or qualified personnel in the
following cases:
– Immediately after unpacking, in the event of
doubts regarding the integrity of the device
– During installation (according to the
manufacturer's instructions)
– Doubts regarding the correct operation of the
device
– Malfunction or poor operation
– Replacing the power socket if incompatible with
the power plug of the device
– Damage to the power cable or need of replacing
the power cord or plug

InformaTIon for energy savIng

The operating modes GenTle HeAT and HOT
AIR consume less energy than the other cooking
functions available.
Avoid frequent door opening.
Z X
Preheat as rapidly as possible.
Z X
Preheat the oven chamber only if the baking
Z X
results depend on this operation.
If a recipe for a gratin uses residual heat for
Z X
longer than 30 minutes, turn the appliance off
5–10 minutes before the end of cooking.
FS 913 M / FS 913 P

Taking out of service

If the oven is no longer to be used, call the service
Z X
centre or qualified personnel to disconnect it from
the power supply.
– 8 –