Storck POWER ARMS SL Bedienungsanleitung Seite 57

Remove the clamping screw.
Apply a screw locking device of medium con-
sistency (Loctite or similar) to the thread of the
clamping screw.
Replace the clamping screw.
Pull up the clamping screw to 8Nm torque.
Apply a screw locking device of medium con-
sistency (Loctite 222) and pull up the adjusting
bolt to maximum 3Nm torque in order not to
loose it during the travel.
10
(Fig. 10)
Installation of your Powerarms SL is now finished.
(Fig. 11)
11
Apply grease liberally to the threads of the pedals
Install your pedals.
! Right-hand pedal: Right-hand thread!
CAUTION !
Left-hand pedal: Left-hand thread!
Danger of damage to the carbon structure in the
area of the pedal threads.
It is essential not to confuse the RH and LH
pedal!
Do not exceed the maximum tightening
torque prescribed by STORCK for the pedals
– max. 20Nm!
NOTE !
It is essential to read and observe the safety and
working instructions given in the manual of the
manufacturer of your pedals!
ASSEMBLY
57