Mounting The Spiked Bumper; Engaging And Disengaging The Chain Brake; Engaging The Chain Brake - Stihl MSA 161 T Gebrauchsanleitung

7 Engaging and Disengaging the Chain Brake

1
2
► Place the cap in the filler opening so that mark (1) lines up
with mark (2).
► Press the cap down and rotate it clockwise as far as stop.
The cap snaps into place. The mark (1) points to mark (3),
► Check to see if the oil tank cap can be pulled upwards and
off.
► If the oil tank cap cannot be pulled upwards and off: Fold
down the grip on the oil tank cap.
The oil tank is closed.
If the oil tank cap can be pulled upwards and off, perform the
following steps:
► Place the oil tank cap in the filler opening – in any position.
► Press the cap down and rotate it clockwise as far as stop.
► Press the cap down and rotate it counterclockwise until
mark (1) points to mark (2).
► Now try again to close the oil tank.
0458-791-9621-A
► If the oil tank still cannot be closed properly: Do not use
the chainsaw and contact a STIHL dealer for assistance.
The chainsaw is not in a safe condition.
1
6.4
3
► Take out the screw (4) and remove the chain catcher (3).
► Place the spiked bumper (1) in position.
► Fit the screw (2).
► Place the chain catcher (3) in position.
► Insert and tighten down the screw (4) firmly.
► Tighten down the screw (2) firmly.
7 Engaging and Disengaging the Chain
1
7.1
The saw is equipped with a chain brake.
The chain brake is activated by the inertia of the front hand
guard if the kickback force is high enough or can be engaged
by the operator.
2

Mounting the Spiked Bumper

3
Brake

Engaging the Chain Brake

English
1
2
4
53