Mounting The Machine Support; Adjusting Special Harvester For User; Fitting And Adjusting The Carrying System - Stihl SPA 65 Gebrauchsanleitung

8 Adjusting Special Harvester for User

1
2
► Screw the tine (1) into the rake (2) and tighten it down
firmly by hand.
► Use a 16 mm ring wrench to turn the tine (1) another 1/8
turn.
7.1.2 Removing the Tines
► Switch off the special harvester, push retaining latch to
position and remove the battery.
► Loosen tine with a 16 mm ring wrench.
► Unscrew the tine by hand.
7.2

Mounting the Machine Support

► Switch off the special harvester, push retaining latch to
position and remove the battery.
1
2
► Position the left half of the machine support (2) against the
side of the cover.
► Fit the screw (1).
0458-704-9921-C
1
5
3
4
► Position the right half of the machine support (4) against
the side of the cover.
► Fit the screw (5).
► Insert and tighten down the screws (4) firmly.
► Tighten down the screws (1) and (5) firmly.
The machine support (2) need not be removed again.
8 Adjusting Special Harvester for User
8.1

Fitting and Adjusting the Carrying System

► Put on the shoulder strap (1).
► Adjust the shoulder strap (1) so that the carabiner (2) is
about a hand's width below your right hip.
English
1
2
37