Adapting The Programming; Maintenance Operations; Mowing Blade Maintenance; Technical Specifications - Stihl ALM 030 Gebrauchsanleitung

● Following installation of a new mowing
blade, confirm the blade replacement in
the "Service" menu (see instruction
manual for the robotic mower).
3.3 Removing ALM 030
Removing the mowing blade
● Push in both tabs (1) on the
blade support with one hand and
hold. Remove fastening nut (C) with
your other hand. Remove the mowing
blade together with the fastening nut.
Removing the blade support
● Insert puller (2) into the blade support
as shown and turn anti-clockwise to the
stop.
● Support the machine with one hand,
remove blade support (B) by pulling on
puller (2).
4. Notes on mowing

4.1 Adapting the programming

The robotic mower mows the mowing area
automatically as usual when the mowing
blade ALM 030 is fitted.
The bigger cutting width enables the
mowing duration to be reduced by up to
10% – see the section "Adapting the
programming" in the instruction manual for
the robotic mower.
6
All manuals and user guides at all-guides.com
5. Maintenance

5.1 Maintenance operations

● Weekly Carry out a weekly visual
6
inspection of the mowing blade, blade
7
support and fastening nut for damage
(notches, cracks, fractures, etc.) and
wear.
● Replace the mowing blade every 200
hours.
Replacement blade (30 cm):
6309 702 0102
5.2 Cleaning
● Clean the mowing blade weekly
(e.g. with a brush). If the noise
produced by the machine increases
during mowing, remove any dirt from
the mowing blade, blade support and
mowing deck housing more frequently.
The mowing blade and blade support
can also be installed offset by 180°.

5.3 Mowing blade maintenance

Risk of injury!
In particular, check for wear on the
mowing blade; the same wear limits
apply as for the original mowing
blade.
The mowing blade, blade support
and fastening nut must be
replaced if damaged (e.g. broken,
worn).
● Maintain the mowing blade as per the
instruction manual for the robotic
mower.
● For information on removing and
installing the mowing blade, see the
sections "Removing ALM 030" (
and "Installing ALM 030". (

6. Technical specifications

The following technical data of the robotic
mower changes when the accessory
ALM 030 is fitted:
Cutting width 30 cm
Sound emissions:
In accordance with Directive 2006/42/EC
and the EN 50636-2-107 standard:
Measured sound
power level L 64 dB(A)
WA
Uncertainty K 3 dB(A)
WA
L + K 67 dB(A)
WA WA
Sound pressure level
L 53 dB(A)
pA
Uncertainty K 3 dB(A)
pA
0478 909 9928 A - EN
3.3)
3.2)