TIPTEL DECT Box 5000 CLIP Bedienungsanleitung Seite 35

2 Registration / programming
Function
Block dialing off
This standard mode transmits the dialed number digit by digit from
connected analogue device to the DECT Box.
Block dialing active
In Block dialing mode the dialed digits are "queued" in DECT Box
300/5000. Dialing the required number followed by
the dialed number being transmitted in one block to the DECT Box.
This enables usage on base stations which are expecting block
dialing mode.(Example: Gigaset C590)
For this Function please activate Parameters as shown below:
Parameter 49 = 1
Parameter 42 = 1
Parameter 71 = 0
Factory setting: 0
Field strength measurement
The current field strength is indicated on the handset by means of
five signals of differing pitch, the highest pitch indicating the best
reception. This ensures optimum set-up of the aerial for the base
station.
Parameter query
A CLIP-compatible telephone can be used to read the current setting
of different parameters. After entering the relevant parameter code
and confirming this with
then receive a call from the DECT Box and the parameter code and
the current status will be shown on the display.
Example: Enter
display shows 3#45
#
, replace the telephone handset. You will
* * 9 5 1 3 #
11
Parameter Other input
code
49 0 #
49 1 #
#
will result in
50 #
51 Parameter-
code #
, replace the handset, call,