TIPTEL DECT Box 5000 CLIP Bedienungsanleitung Seite 33

2 Registration / programming
Function
Distance (DECT Box 5000 only)
Valid entries are 0 - 79.
The setting can be determined using the following mathematical
formula:
Distance value = distance [in m] divided by 130
Example: 2,300 m : 130 m = 17.69 -> distance value = 18
This setting has to be changed only for distances of more than
800 m. For shorter distances the parameter setting will stay on 0.
This may vary depending on the base station being used. Adjust
the distance value in increments of two.
Factory setting: 0
Connection to an ISDN/
analogue line
Send keypad information, while connection Keypad information will
be suppressed, so it is possible to transmit DTMF signals.
This setting has to be used if your base station is connected to an
ISDN phone line.
Suppress keypad information: This setting has to be used if your
base station is connected to an analogue phone line.
Send always keypad information. This setting has to be used if your
base station is a specified ISDN system.
Factory setting: 1
Fax / Data mode
"Telephone" Mode: This setting should be used if a telephone is
connected to the DECT Box.
"Fax" Mode: This setting should be used if a fax machine or modem
is connected to the DECT Box. The setting may improve transmission
quality.
Factory setting: 0
Parameter Other input
code
3
40
40
40
41
41
9
Distance value #
0 #
1 #
2 #
0 #
1 #