Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
NOTE
NOTE
2
Registration / programming
The DECT Box must be registered on your DECT/GAP base station
before it can be used. The registration process can normally be
carried out using the "Automatic registration" function.
"Programming mode" allows you to set various parameters to
modify the DECT Box to suit the functionality of your base station.
Additional parameters allow the DECT Box to be set according to
your personal preferences. Manual registration can also be carried
out in this mode.
2.1
Automatic registration
The DECT Box can be registered automatically, assuming it has not
been registered on any other base station yet. To do this, the PIN on
your base station must be set to "0000" or "1111".
1. Connect the power supply unit (adapter) to your DECT Box.
2. Connect your telephone to the DECT Box, leaving the handset on
the hook.
3. Ensure that your base station enables an additional cordless pho-
ne to be registered.
4. During the registration process, the DECT Box should be located
close to your base station.
5. Start the registration procedure for the device on your DECT/GAP
base station as if you were registering an additional cordless unit.
Instructions on how to do this will be given in the operating
manual for your base station.
6. Plug the power supply unit into a power socket. The registration
process will be started automatically.
7. The registration process has been successful if the LED flashes at
intervals of approx. 10 seconds.
If the registration process has not been completed successfully
within approx. 3 minutes, register the device manually in pro-
gramming mode.
2.2
Programming mode
Programming mode on the DECT Box can only be activated within
the first 10 minutes after plugging in the power supply unit. This pre-
vents the parameters being changed accidentally during operation.
Not all the features offered by the device are supported by every
6
Werbung
Kapitel
Inhaltsverzeichnis
