Activating Programming Mode - TIPTEL DECT Box 5000 CLIP Bedienungsanleitung

NOTE
Example
2 Registration / programming
DECT/GAP base station. Refer to the operating manual for your base
station to clarify which features you can use.

2.2.1 Activating programming mode

Proceed as follows to change the DECT Box to programming mode:
1. Connect your telephone to the DECT Box.
2. Connect the power supply unit to your v.
3. Plug the power supply unit into a power socket. Leave the phone on
the hook for at least 30 seconds.
4. Lift the handset on your telephone. Depending on whether or not
your DECT Box is already registered on a base station, you will either
hear a busy tone or a dialling tone.
5. On your telephone, enter
6. You will hear a positive acknowledgement tone.
7. Optional step: Enter the PIN for the DECT Box via your telephone.
The PIN only needs to be entered if a new PIN has been set up
beforehand in programming mode.
Access to programming mode can be protected using the PIN!
8. You will hear the special dialling tone indicating that programming
mode is active.
You can now enter the parameter codes to change the relevant features
of your DECT Box.
Let's say, for example, you want to use your DECT Box on a base station
with an ISDN telephone connection. Activate programming mode as
described above in points 1-8 and then proceed as follows:
1. Enter the programming code for connection to an ISDN/analogue line:
4 0
.
2. To activate the feature, enter
3. You will hear a positive acknowledgement tone, followed by the
special dialling tone once more. The feature is now active.
* * 9
.
0 #
.
7