Setting Parameters In Programming Mode - TIPTEL DECT Box 5000 CLIP Bedienungsanleitung

NOTE
2 Registration / programming

2.2.2 Setting parameters in programming mode

Not all the features offered by the distybox are supported by every
DECT/GAP base station. Refer to the operating manual for your base
station to clarify which features you can use.
Programming mode needs to be activated before this parameter can be
set. The function-programming process is concluded by entering
confirmed by the positive acknowledgement tone. You will then hear
the special dialling tone once more, which means that you can continue
programming other functions. With the exception of programming
points 90, 91 and 99, the change is effective without having to restart
the DECT Box.
If an invalid value is entered during programming, a negative acknow-
ledgement tone is sounded, the procedure is cancelled and you will hear
the special dialling tone once more.
If during programming no input is made for one minute, the procedure is
cancelled and you will hear the special dialling tone again.
Programming mode can be left at any time by replacing the handset; the
DECT Box will then return to normal mode.
Function
Manual registration of
the DECT Box
The base station PIN needs to be entered to register the DECT Box.
A PIN with 4 to 8 digits will be accepted by the DECT Box. After entering
#
you will hear the positive acknowledge tone. Leave the handset off
hook and wait until you hear again the special dial tone, which means
that the registration is completed. If the registration process has not
been completed successfully within approx. 3 minutes, crosscheck the
settings of the base station and try again. Access to programming mode
can be protected using the four-digit PIN.
Changing the PIN
Access to programming mode can be protected using the four-digit PIN.
The PIN only needs to be entered if a new PIN has been set beforehand
in programming mode. To change the PIN, activate programming mode,
enter the new PIN twice and confirm this by pressing
confirmed by the positive acknowledgement tone. Programming mode
can then only be accessed again by entering the new PIN once more.
If you forget the PIN, the DECT Box can only be reset by the Customer
Service department.
Factory setting: 0 0 0 0
Parameter Other input
code
1
2
8
#
and
Base PIN #
new PIN new PIN #
#
. The change is