Emptying The Vacuuming Material Container; Transport; Storage; Care And Maintenance - Kärcher IV 60/24-2 W Originalbetriebsanleitung

Emptying the vacuuming material
To avoid too much filling of the vacuuming
material container, you need to check it
regularly depending on the type and vol-
ume of the sucked in material.
 Switch off the appliance and secure it
using the parking brakes at the guide
rollers.
 Open the vacuuming material container
upward at the lock (see figure).
 Pull out the vacuuming material con-
tainer from the appliance using the han-
dle that has been provided for the pur-
pose.
Note: The vacuuming material container
must be emptied if it is filled to approx. 3 cm
below the upper edge.
 Empty the vacuuming material contain-
er and insert it back into the appliance
using the reverse sequence.
16
container
CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport it.
 Release the park brakes and push the
appliance by the push handle.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Care and maintenance

DANGER
Risk of injury by inadvertent startup of ap-
pliance and electrical shock.
First pull out the plug from the mains before
carrying out any tasks on the machine.
WARNING
Safety equipment for preventing hazards
must be serviced and maintained regularly.
This means that the manufacturer's staff or
persons trained by the manufacturer must
check the equipment for proper functioning
at least once a year, i.e. check for leaks, fil-
ter damage, functioning of the controlling
elements, etc.
– No outside help is required for carrying
out basic maintenance and cleaning.
– The appliance surface and the inside of
the container should be cleaned regu-
larly using a damp cloth.
Cleaning the filter
 Tilt the fastener for filter dedusting to-
wards the side.
 Vigorously move the handle for filter
cleaning up and down several times.
 Place the fastener for filter dedusting in
a vertical position.
If this cleaning does not lead to improve-
ment, the filter can be removed and
washed or replaced (see Chapter "Ex-
changing/replacing the filter").
– 5
EN

Transport

Storage