Troubleshooting - Kärcher IV 60/24-2 W Originalbetriebsanleitung

Changing/ replacing filter
 Switch off the appliance using the ON/
OFF switch and separate it from the
mains.
1 Handle for filter cleaning
2 Spring
3 Fastener for filter dedusting
4 Suction head cap
 Tilt the fastener for filter dedusting to-
wards the side.
 Unscrew the handle for cleaning the fil-
ter.
 Remove the spring.
 Unscrew the nut below the spring (you
will need a spanner with width 27 mm).
 Open both the suction head caps.
1 Suction head
2 Frame
3 Filter
 Remove the suction hand.
 Open the knot of the tapes on the filter
and remove the frame.
 Take out the filter.
 Insert and secure the new filter in the re-
verse sequence of steps.

Troubleshooting

DANGER
Risk of injury by inadvertent startup of ap-
pliance and electrical shock.
First pull out the plug from the mains before
carrying out any tasks on the machine.
DANGER
Have all checks and works on electrical
parts performed by an expert.
Motor (suction turbine) does not
No electrical voltage.
 Check the receptacle and the fuse of
the power supply.
 Check the power cable and the power
plug of the device.
Suction capacity decreases slowly
Filter, nozzle, suction hose or suction pipe
may be blocked.
 Check, clean the accessories, replace
the filter, if required.
Dust comes out during the
Filter has not been fastened correctly or is
defective.
 Check to see if filter is sitting properly;
replace if required.
Manometer indicates a negative
suction pressure below -0.16 bar (-
Filter is blocked.
 Switch off the appliance, clean the filter
or insert a new filter.
Indicator lamp "Filter blocked"
Filter is blocked.
 Switch off the appliance using the ON/
OFF switch and separate it from the
mains.
 Clean filter.
 If a filter cleaning does not lead to suc-
cess, replace the filter.
– 6
EN
start
vacuuming
16 kPa)
glows
17