Coolant Level Check - SWM RS 300 R Handbuch

• Refit everything operating in reverse order from
removal taking care to correctly position the O-
ring (18) and the spring (19).
WARNING*: the longer screw (15a) is to be fitted
exactly in the position indicated in the figure.
15a
16
15
19

COOLANT LEVEL CHECK

Check level (1) in right-hand radiator when engine is
cold (place the motorcycle so that it is perpendicular
to the ground). The coolant should be approximate-
ly 10 mm above cells and besides, it shall not exceed
the middle of the expansion tank (2) located in front
of the rear shock absorber.
The radiator cap (3) features two locking positions,
the first being for the previous pressure discharge
of the cooling system.
CAUTION*: Avoid removing radiator cap (3)
when engine is hot, as coolant may spout out
and cause scalding.
18
1
17
2
CAUTION*: Because the cooling fan (4) can be
activated even when the start switch is in OFF
position, always keep at a safe distance from
the fan blades.
Note*: Difficulties may arise in eliminating coolant
from painted surfaces. If this occurs, wash off with
water.
3
4
EN - 23