Oil Quantity In Each Fork Leg - SWM RS 300 R Handbuch

ADJUSTING THE FRONT FORK
a) REBOUND (TOP ADJUSTER)
Standard setting:
- RS: 10 clicks.
- SM: 8 clicks.
To reset standard calibration, turn adjuster (C)
clockwise to reach the fully closed position; then,
turn it back by the mentioned clicks. In order to
obtain a smooth braking action, turn the adjuster
counter clockwise. Vice versa to obtain a harder
braking action.
b) COMPRESSION (UPPER REGISTER)
Standard calibration :
- RS: 10 clicks.
- SM: 8 clicks.
To reset to the standadr calibration turn register (A)
clockwise until the position of fully closed is reached
then, turn back by the mentioned clicks. To obtain
a smoother braking action, turn the register anti-
clockwise. Reverse the operation in order to obtain
a harder action.
- AIR VENT (to carry out monthly).
Set the motorcycle on a central stand, release the
fork fully extended and loosen the air vent valve (D).
Once this operation is over, tighten the valve.
Note*: Never force the adjusting screws beyond the
maximum open and closed positions.
EN - 36
a
D
b
A
FORK OIL LEVEL
For regular fork operation, both legs must be pro-
vided with the necessary oil quantity. Remove the
fork legs from the fork to check the oil level. Work
as follows:
- remove the damper rod caps;
- remove springs from the legs letting the oil drain
into the legs;
- bring fork to stroke end;
C
- check that the level is at distance "A" below the
upper limit of damper rod.
OIL QUANTITY IN EACH FORK LEG
- RS: 39.23 in 3 . (643 cm
3
- SM: 41.06 in . (673 cm
- A: 5.51 in. (140 mm) - RS
- A: 4.72 in. (120 mm) - SM
with fork leg fully compressed and without spring.
Note*:
Standard spring elastic constant:
- RS: K= 8.8 N/mm
- SM: K= 10 N/mm
Note*:
Always replace both the spring and the spacers to
keep the preload value unchanged.
3 )
3
)
A