Options - Lap Belt; Options - Therapy Table; Options - Crutch Holder - Breezy PariX2 Gebrauchsanweisung

options - lap Belt

WARNING!
Before using your wheelchair ensure
the seat belt is worn and correctly
adjusted before use.
The lap belt is fitted to the
wheelchair as shown in the
illustrations. The seat belt comprises
2 halves. They are fitted using the
existing arm rest fixing bolt fitted
through the eyelet on the belt.
The belt is routed under the rear of
the side panel.
Adjust the belt position so buckles
are in the centre of the seat.
(Fig.25-26)
adjust lap belt to suit the user's needs as follows:
To increase the belt To reduce the belt
length
Type A
Type B
Feed free belt Feed free belt back
through slide adjust- through male buckle
ers and male buckle and slide adjusters.
to provide more belt
length.
When fastened check space
between the lap belt and user, when
correctly adjusted it should not be
possible to insert more than the flat
of the hand between the lap belt and
the user. (Fig. 27)
Generally the Lap Belt should be
fixed so that the straps sit at an
angle of approximately 45°, and
when correctly adjusted should not
allow user to slip down in the seat.
12 PariX 2
FiG. 25
FiG. 26
length
Type A
Type A
Type B
Type B
Ensure belt is not
looped at male
buckle.
Fig. 27
to fasten buckle:
Firmly push male buckle into
female buckle.
advice to clieNt
daNGer!
• Do not rely on the lap belt only when the wheelchair and
occupant are transported in a vehicle, use the separate
occupant lap and diagonal restraints provided in the vehicle.
• Before use we recommend that the lap belt be checked to
ensure that it is adjusted correctly, free from any obstruction or
adverse wear and that the buckle engages securely.
• Failure to make sure that the lap belt is secure and adjusted
prior to use could cause serious injury to the user. e.g. too
loose a strap may allow the user to slip down in the chair and
risk suffocation.
Maintenance:
Check lap belt and securing components at regular intervals for
any sign of fraying or damage. Replace if necessary. Clean the lap
belt with warm soapy water and allow it to dry.
daNGer!
The lap belt should be adjusted to suit the end user as detailed
above Sunrise Medical also recommend that the length and fit of
the belt is checked on a regular basis to reduce the risk of the end
user inadvertently re-adjusting the belt to an excessive length.
If in doubt about the use and operation of the seat belt then ask
your healthcare professional, wheelchair dealer, carer or attendant
for assistance.

options - therapy table

theraPy taBle
The tray provides a flat surface for
most activities. Before using a tray,
it first has to be adjusted to the
width of the seat by an authorised
dealer. The user must be sitting in
the wheelchair during this
adjustment (Fig. 28).

options - crutch holder

Fig. 29
to release belt:
Press exposed sides of male
buckle and push towards
centre / push the press button
of the female buckle whilst
gently pull ing apart.
Fig. 28
Fig. 30