Troubleshooting - Kärcher KMR-TRAC Bedienungsanleitung

English

Troubleshooting

Fault
Sweeper does not start up
Engine is running, but sweeper
does not move
Unit does not sweep properly
Unit blows out dust
40
User Instructions
Possible cause
No weight on driver seat
(Contacts on seat switch)
Clutch/brake pedal not
depressed
Defective safety switch
Tap in fuel line closed
Fuel tank empty
Flat battery
Worn out or defective spark plug
Blown fuse
Loose or torn belt
Worn out or damaged brush
roller
Loose belt
Coarse-dirt flap sticking
Blocked or defective plate filter
Worn out or damaged sealing
skirts
Blocked suction hoses
Coarse-dirt flap sticking
KMR – TRAC
Remedy
Sit on driver seat
Press down on clutch/brake
pedal, and hold in position
Replace seat switch or clutch
pedal switch (Customer Service)
Open fuel tap
Fill up with petrol
Recharge battery
Replace spark plug
(Customer Service)
Replace fuse
Re-tension or replace belt
(Customer Service)
Replace brush roller if worn out,
damaged or when bristles are
down to 50 mm in length
Re-tension belt
(Customer Service)
Ensure coarse-dirt flap can move
freely
Clean off or replace filter
Replace sealing skirts
Clean out suction hoses
Ensure coarse-dirt flap can move
freely