Prior To Initial Start-Up; Unpacking The Sweeper; Assembly - Driver Seat; Assembly - Steering - Kärcher KMR-TRAC Bedienungsanleitung

English

Prior to initial start-up

24
User Instructions

Unpacking the sweeper

The machine has been secured to a pallet to keep it
safe during transport. Unpack the unit as follows:
Cut plastic band.
Remove chocks from under wheels, and drive unit
down a ramp and off pallet, or
lift unit by hand over chocks and off pallet.
Assembly – driver seat
Insert 4 enclosed spacers between seat and folding
support mechanism, adjust seat to required position,
and secure tightly using four bolts (SW 9/16" / SW14).
Assembly – steering
Position front wheels so that they are pointing forward
in a straight line.
Mount the cover over the steering column.
Set steering wheel to required position. Ensure that
steering wheel is properly seated on end of steering
column.
Place dome-shaped washer, with raised side pointing
upwards, onto steering spindle. Secure with nut
(SW 1/2" / SW13).
Place cap on centre of steering wheel, and press
firmly.
Air pressure – tyres
During transport the air pressure in the tyres may have
become too high.
Check tyre pressure before starting unit.
Recommended air pressure is approx. 0.9 bar
(12 psi).
All four tyres must have the same air pressure.
Check the pressure at regular intervals.
KMR – TRAC