Accessories; Warranty; Troubleshooting - Kärcher KM 100/100 R Bp Originalbetriebsanleitung

Pole fuse
1 Nut
2 Battery charging cable
3 Pole fuse
4 Jumper
5 Screw
 Replace defective fuse.
Note:A defective pole fuse may only be re-
placed by a Kärcher service technician or
an authorised expert.
Danger
Fault
Appliance cannot be started
Appliance moves only slowly
Machine is not sweeping properly Check roller brush and side brushes for wear, replace if necessary.
Dust gathers in the machine
Side brush does not turn
Poor cleaning performance at edg-
es
Side brush or roller brush switch-on
operation is not working

Accessories

Side brushes
With standard bristles for indoor and out-
door areas.
Side-brushes, soft
For fine dust on inside surfaces; wetness
resistant.
Hard side-brushes
For removing stubborn dirt in the external
area; resistant to moisture.
Standard sweep roller 6.906-375.0
Resistant of wear and moisture. Universal
bristles for inside and outside cleaning.
Roller-brush, soft
With natural bristles especially for fine dust
sweeping on smooth indoor floors. Not re-
sistant to wetness; not for abrasive surfac-
es.
Roller-brush, hard
For removing stubborn dirt in the external
area; resistant to moisture.
Dust filter
Battery set
Charger

Troubleshooting

Risk of injury! Before carrying out any tasks
on the machine, set the main key to "0" and
remove it. Press emergency-stop button.
Remedy
Sit on the driver seat, the seat contact switch gets activated.
Release emergency-stop button
Set main switch to "1"
Check the fuses.
Check battery; charge it if required.
Inform Kärcher Customer Service.
Check the position of the immobilizing brake
Inform Kärcher Customer Service.
Check function of bulk waste flap
Check sealing strips for wear, adjust or replace as required
Check belts of sweeping drive.
Check vacuum pressure system to see it is leak-proof.
Inform Kärcher Customer Service.
Empty waste container
Check suction fan drive belt
Check sealing cover on suction fan
Check dust filter, clean or replace
Do not rinse out the dust filter.
Check filter case seal
Close wet/dry flap
Check sealing strips for wear, adjust or replace as required
Inform Kärcher Customer Service.
Check the fuse.
Inform Kärcher Customer Service.
Replace side brush
Check sealing strips for wear, adjust or replace as required
Inform Kärcher Customer Service.
Check vacuum pressure system to see it is leak-proof.
Inform Kärcher Customer Service.
EN
The warranty terms published by the rele-
6.905-986.0
vant sales company are applicable in each
country. We will repair potential failures of
your appliance within the warranty period
6.906-133.0
free of charge, provided that such failure is
caused by faulty material or defects in man-
ufacturing. In the event of a warranty claim
please contact your dealer or the nearest
6.906-065.0
authorized Customer Service center.
Please submit the proof of purchase.
6.906-533.0
6.906-532.0
6.414-532.0
6.654-112.0
6.654-143.0
11
-

Warranty

27