Initial Installation - Sharp PN-Q901 Bedienungsanleitung

Introduction

Initial Installation

Perform the following steps before you
press POWER on the remote control unit.
1
Insert the batteries into the remote
control unit.
2
Plug in the AC cord to the AC outlet.
Language (Language setting)
Select from among 6 language: English,
French, Spanish, German, Italian and
Russian.
1
Press a /b to select the desired
language listed on the screen, and
then press ENTER.
Power Saving
Select "Yes" or "No" to configure default
Display seting.
2
Press c / to select "Yes" or "No".
Press ENTER to enter the setting.
Completed
3
The settings confirmation screen is
displayed. Confirm the information
displayed on the screen, and then
press ENTER.
Examples of the settings
confirmation screen
EN 9
Viewing the Built-in Operation Manual
Viewing the Built-in Operation Manual
Press MANUAL on the remote control unit to display operation information on the screen.
To search for an item from the table of contents, and to search for a particular term and to find troubleshooting
information, press MANUAL while watching the Monitor and then select the applicable item from the manual
cover page that appears.
1
Press MANUAL while watching the Monitor.
This displays the built-in operation manual screen.
2
When you select contents, its page will be displayed.
3
You can turn over the page one by one for these arrow marks.
2
1
NOTE
• You can also display the built-in operation manual by selecting "Information" > "Manual" from the menu screen.
• When USB mode, Home Network mode, or Internet application is used, can not be displayed the built-in operation
manual.
3
ETH ERN
ET term inal
PC IN AUD IO IN
term inal
term inal (shar ed for
PC IN and
HDM I IN
2) *2
VIDE O IN
1 term inals
AUD IO OUT
term inals
COM PON
ENT /
VIDE O IN
term inals *5
HDM I IN
HDM I IN 2 term inal
1 term inal
ARC : Audi
o
Retu rn Chan
nel *3
DIGI TAL
AUD IO OUT
term inal