Additional Safety Instructions; Noise And Vibration - Flex LD 2806 CT Bedienungsanleitung

 Keep your body out of the area into which
the electric power tool moves when
a recoil occurs.
Kickback propels the electric power tool in the
direction opposite to the movement of the
sanding disc at the point of pinching.
 Work especially carefully near corners,
sharp edges, etc. Prevent the insertion
tool from recoiling off the workpiece and
jamming.
The rotating insertion tool has a tendency to
snag on corners, sharp edges or if it bounces.
This causes a loss of control or kickback.
 Do not use a chain or toothed saw blade.
Such insertion tools frequently cause
a kickback or the loss of control of the electric
power tool.

Additional safety instructions

 Use only extension cables permitted for
outdoor use.
 It is not recommended to sand lead paint.
Lead paint should be removed by
a specialist only.
 Do not work on materials which release
hazardous substances (e.g. asbestos).
Take precautions if hazardous, combustible
or explosive dust is likely to occur.
Wear protective dust mask. Use dust
extraction system.
a^j^db=ql=molmboqv>
 The mains voltage and the voltage
specifications on the rating plate must
correspond.
16

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 60745.
The A evaluated noise level of the power tool is
typically:
– Sound pressure level:
– Sound power level:
– Uncertainty:
Total vibration value (when sanding concrete
areas):
– Emission value:
– Uncertainty:
`^rqflk>
qÜÉ=áåÇáÅ~íÉÇ=ãÉ~ëìêÉãÉåíë=êÉÑÉê=íç=åÉï=
éçïÉê=íççäëK=a~áäó=ìëÉ=Å~ìëÉë=íÜÉ=åçáëÉ=~åÇ=
îáÄê~íáçå=î~äìÉë=íç=ÅÜ~åÖÉK
klqb
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in
EN 60745 and may be used to compare one
tool with another. It may be used for
a preliminary assessment of exposure.
The declared vibration emission level represents
the main applications of the tool.
However if the tool is used for different
applications, with different accessories or poorly
maintained, the vibration emission may differ.
This may significantly increase the exposure
level over the total working period.
For a precise estimation of the vibration load the
times should also be considered during which
the power tool is switched off or even running,
but not actually in use. This may significantly
decrease the exposure level over the total
working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
`^rqflk>
tÉ~ê=É~ê=éêçíÉÅíáçå=~í=~=ëçìåÇ=éêÉëëìêÉ=
~ÄçîÉ=UR=Ç_E^FK
LD 2806 CT
93 dB(A);
104 dB(A);
K = 3 dB.
2
a = 7.6 m/s
h
2
K = 1.5 m/s