Operating Instructions - Flex LD 2806 CT Bedienungsanleitung

Operating instructions

`^rqflk>
qÜÉ=~î~áä~ÄäÉ=ã~áåë=îçäí~ÖÉ=~åÇ=íÜÉ=îçäí~ÖÉ=
ëéÉÅáÑáÅ~íáçåë=çå=íÜÉ=ê~íáåÖ=éä~íÉ=ãìëí=ÄÉ=íÜÉ=
ë~ãÉK
t^okfkd>
_ÉÑçêÉ=éÉêÑçêãáåÖ=~åó=ïçêâ=çå=íÜÉ=ÉäÉÅíêáÅ=
éçïÉê=íççäI=éìää=çìí=íÜÉ=ã~áåë=éäìÖK=
Before switching on the power tool
 Unpack power tool and accessories and
check that no parts are missing or
damaged.
Inserting and changing the sanding
tools
 Press and hold down the spindle lock (1.).
 Using the stop key, loosen the clamping nut
on the spindle in an anti-clockwise direction
and remove (2.).
 Insert diamond sanding pad (B) correctly.
18
 Screw the clamping nut (A), with flange face
up, onto the spindle.
 Press and hold down the spindle lock.
 Tighten the clamping nut with the stop key.
Check position of the guard
The rubber extraction ring should protrude over
the sanding pad by approx. 0–1 mm.
If required, correct (see "Adjusting the guard").
 Insert the mains plug into the socket.
 Switch on the electric power tool (without
locking the button) and leave it running for
approx. 30 seconds. Check for imbalances
and vibrations.
 Switch off the electric power tool.
LD 2806 CT