Correct Use; General Safety Notes And Protective Measures - Sick In4000 Direct Bedienungsanleitung

Operating instructions
IN4000 Direct
8012183/YTC9/2016-04-12
Subject to change without notice
On safety
2.3

Correct use

The safety switches of the IN4000 Direct series must
be used only as defined in section 2.2 "Applications of
the safety switches" on page 56. The safety switches
are only allowed to be installed by qualified safety
personnel and are only allowed to be used on the
machine on which they have been installed and
initialized by qualified safety personnel as per these
operating instructions.
All warranty claims against SICK AG are forfeited in the
case of any other use, or alterations being made to
devices, even as part of their mounting or installation.
2.4 General safety notes and
protective measures
The IN4000 Direct safety switch provides a personnel
protection function. Incorrect installation or manipula-
tion can result in serious injuries.
The IN4000 Direct safety switch complies with the
following safety requirements:
• Category 4/Performance Level e according to
EN ISO 13 849-1 (depending on application)
• SIL3 according to IEC 61 508
• SILCL3 according to EN 62 061
Note on the classification of the device according to
EN 60 947-5-2:
• The IN40-E0101K safety switch complies with the
classification I1C40SP2M or I2C40SP2M depending
on the installation.
• The IN40-E0109K safety switch complies with the
classification I1C40SP2M or I2C40SP2M depending
on the installation.
© SICK AG • Industrial Safety Systems • Germany • All rights reserved
en
Chapter 2
57