Troubleshooting - Klarstein Aromatica II Bedienungsanleitung

After descaling:
1 Place the carbon filter holder (20) in the water reservoir (14).
2 Close the cover (24).
3 Switch off the appliance by pressing the on/off button (1).
4 Keep the coffee quantity selector (3) and the coffee strength selector (4) pressed
until the indicator (D) disappears from the display (8) (fig. C).
5 Clean the outside of the appliance with a damp cloth. Dry the outside of the
appliance with a clean, dry cloth.
6 The appliance is ready for use.
Replacing carbon filter
1 Open the cover (24).
2 If necessary, empty the water reservoir (14).
3 Remove the carbon filter holder (20) from the water reservoir (14).
4 Open the cover (25).
5 Remove the old carbon filter (26).
6 Place the new carbon filter (26).
7 Close the cover (25).
Note: The carbon filter holder must not be placed in the water reservoir before the
appliance has been descaled. This does not apply the first time you put the appliance
into operation.

TROUBLESHOOTING

Problem Possible Cause
Not plugged in.
No symbol in the
No mains power.
display.
Display is defective.
Too many appliances
connected to the same
The automatic circuit
power
breaker in the fuse
circuit.
box trips
Appliance defective.
Water runs out of the Too much water in the water
appliance tank.
Suggested Solution
Insert the plug.
Check the fuse/socket.
Contact customer service.
Plug the device into its own
power socket.
Contact customer service.
Do not overfill the water tank
EN
37