Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
What to do if no steam comes out of the steam attachment?
• This is usually because the steam pipe and the steam cap have not been cleaned
after milk frothing and milk residues block the steam pipe.
• Try cleaning the pipe with a small cleaning brush.
• If this does not help, add vinegar and water to the water tank at a ratio of 1:1. Then
start the steam function to clean the hose. Then top up with fresh water and restart
the steam function.
• If the problem persists, contact your service representative.

TROUBLESHOOTING

Problem
Liquid runs out of the top
of the fastened strainer
carrier.
The strainer support
cannot be properly locked
and liquid will run out of
the top of the fastened
strainer support.
Cold espresso.
Possible cause
Residues on the seal.
The powder is too fine.
The powder has been
compressed too much.
The seal is old.
Too much powder in the
sieve.
Residues on the seal.
The powder is too fine.
The unit has not been
preheated.
Suggested solution
Remove the residue.
Use coarser powder.
Do not press the powder
too hard into the sieve.
Contact a specialist
company.
Adjust the amount of
powder (see: Frequently
Asked Questions).
Remove the residues.
Use coarser powder.
Wait for the appliance to
heat up before starting the
preparation.
EN
27

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

1003556410035565

Inhaltsverzeichnis