Troubleshooting - Klarstein PAUSA Bedienungsanleitung

TROUBLESHOOTING

Problem Potential cause
No water/steam. There is no water in the
water tank/the water tank
is blocked.
Not enough water has
been added.
The appliance has not yet
preheated.
The espresso is too The coffee powder is too
thin. coarse/ was not pressed
in.
No steam. The steam outlet is
blocked.
The steam button is not
on.
The preheating process is
not yet complete.
The espresso is too Too much or too little
strong or too thin. coffee powder.
The milk does not Whole milk was not used.
foam properly.
The appliance has not yet
preheated.
No coffee, coffee Temperature too high
too weak and after using the steam
steam light function.
flashing rapidly.
The machine does The steam switch is not
not brew coffee. turned off.
Possible solution
Fill the water tank with water, switch on the appliance
and press the coffee button.
Press the hot water button and the machine will start
pumping water into the line until water flows out of
the steam nozzle or funnel.
The appliance must be preheated before making
coffee. The indicator light must be on steadily and
must not be flashing anymore.
Use a finer coffee powder and press this into the filter.
Use a thin wire and plug this through the steam
opening.
Use the hot water function to clean the pipe after milk
frothing.
Before using the steam function, wait until the
preheating process is complete.
Fill the filter with the standard amount of coffee.
One coffee spoon for one cup and press the coffee
powder firmly in the filter. The coffee powder must
be neither too coarse-grained nor too fine-grained.
Coffee powder that is too coarse cannot be extracted
completely and coffee powder that is too fine can
affect the amount of coffee.
Use whole milk.
Only use the steam function when the steam indicator
is permanently lit and no longer flashing.
Use water cooling.
Set the steam switch to the 'OFF' position.
EN
21