Adjusting Of The Tip Cap; Adjusting The Stability And The Maneuverability - Vermeiren Eclips X4 Gebrauchsanweisung

3.10 Adjusting of the tip cap

L L L L
WARNING:
Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
A tip cap is mounted on the lower right back frame that can be adjusted in its height
depending on the seat height of the wheelchair.
The tip cap can be placed in 2 different position with a difference of 15 mm.
If an anti-tip device is installed, it replaces the addition of the tipping lever and can be used
accordingly.

3.11 Adjusting the stability and the maneuverability

L L L L
WARNING:
Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
L L L L
WARNING:
Risk of injury - Make sure that the axle adapters
wheels on both sides are mounted in the same position.
L L L L
WARNING:
Risk of tipping over - Be aware that you change the stability of the
wheelchair.
For the Eclips X4 30° there shall be standard an an ti-tipping device mounted on the
wheelchair when the axle adapter
1. Remove the screws Ⓑ.
2. Adjust the height of the tip cap to a
comfortable position.
Tip cap height
110 mm
(Standard)
125 mm
Table 5: Tip cap heights for wheelchair with standard
seat height of 471 mm
3. Tighten the screws properly Ⓑ.
The driving wheels are mounted in an axle adapter
the bottom of the back frame
1. Loosen the fixing screws
2. Turn the axle adapter
mounting is behind the back frame.
3. Tighten the screws properly
4. Adjust the brakes.
is positioned to the front.
Page 23
Eclips X4, Eclips X4 30°
Tube tip cap Ⓐ Ⓐ Ⓐ Ⓐ Tube frame Ⓒ Ⓒ Ⓒ Ⓒ
Hole 1 and 3 Hole 1 and 3
Hole 1 and 3 Hole 2 and 4
(Fig C)
of the rear
.
.
to the back until the axle
.
2012-01
at