Adjusting Seat Depth; Flexible Back; Adjust The Brakes - Vermeiren Eclips X4 Gebrauchsanweisung

3.5

Adjusting seat depth

L L L L
WARNING:
Risk of injury - Make sure that all screws are properly tightened
before using the wheelchair.
6. Remove the adjustable axle adapter, if available on your wheelchair.
7. Adjust the seat depth to the desired position by moving the backframe
seatframe steps from 20 mm.
8. Tighten all the screws properly by hand.
9. Fold the flap of the backrest under the seat (Velcro fastening), to close the gap between
the back frame and the seat.
10. Adjusting the seat is not necessary.
3.6

Flexible back

L L L L
WARNING:
Risk of injury - Make sure that all screws are properly tightened
before using the wheelchair.
1
3.7

Adjust the brakes

L L L L
WARNING:
Risk of injury – Brakes may only be adjusted by your specialist
dealer.
Adjust the brakes according following rules:
The height of the back can be adjusted by setting the
entire back tube.
For adjusting the height of the back cover, loosen the
fixing screws behind the back tube. Then you can
move the cushion upwards or downwards. There are
fixing holes every 20 mm in the back tube where the
screws can be retightened.
1. Install the wheels according § 2.2.
2. Disconnect the brakes by pulling lever
backwards.
Page 20
Eclips X4, Eclips X4 30°
Adjust the seat depth according
following procedure:
1. Remove the arm supports,
footrests and rear wheels.
2. Loosen the screws
3. Loosen the screws
4. Remove the crosses from the
seat located on the main
frame by folding the
wheelchair.
5. Remove the screws
located in the blocks for the
cross on the main
frame .
and/or
2012-01
.
.