Back Adjusting (Eclips X4 30°); Transport In The Car; Use Of The Wheelchair As Seat In A Motor Vehicle (Eclips X4) - Vermeiren Eclips X4 Gebrauchsanweisung

2.15 Back adjusting (Eclips X4 30° )
L L L L
WARNING:
Risk of tipping over – Be aware that the stability decrease when
adjust the back backwards.
L L L L
WARNING:
Risk of injury – Tighten the parking brakes before adjusting the
backrest inclination.
With the model Eclips X4 30° it is possible to set the backrest backwards with a maximum
inclination of 30° . Be sure that the patient sits i n the chair when the attendant shall perform
the backrest adjusting and that the wheelchair does not tip over.

2.16 Transport in the car

L L L L
WARNING:
Risk of injury – See that the wheelchair is attached properly. So you
can avoid injury from the passengers during collision or sudden braking.
L L L L
WARNING:
Risk of injury – Use for attaching the wheelchair and passenger
NEVER the same seatbelt.
To transport the wheelchair in the car use following steps:
1. Remove footrests and accessories.
2. Store footrests and accessories safely.
3. If possible, fold the wheelchair and remove the wheels.
4. Place the wheelchair in the luggage place.
5. If the wheelchair and the passenger compartment is NOT separated, attach the
frame of the wheelchair securely to the vehicle. You can use the available safety
belts in the vehicle.

2.17 Use of the wheelchair as seat in a motor vehicle (Eclips X4)

The wheelchair shall not be used as a seat in a motor vehicle for the Eclips X4 30° .
L L L L
WARNING:
The wheelchair has passed the crash of ISO 7176-19: 2008 and, as
such, has been designed and tested for use only as forward-facing seat in a
motor vehicle.
L L L L
WARNING:
The wheelchair's pelvic belt alone is not suited as an occupant
restraint belt.
The wheelchair is tested using the four-point strap-tie system and a 3-point occupant-
restraint system.
Whenever feasable, use the seat of the vehicle and store the wheelchair in the cargo area.
1. Pull handle on both sides towards the grab
handle to adjust the back rest.
2. Pull both back tubes backwards continuously to
a maximum inclination of 30° .
3. The gas pressure spring
To set the back to a vertical position, proceed in the
same manner.
If your wheelchair features drum brakes, the
handles are used as brakes; additional levers
have been mounted for backrest adjusting.
Page 14
Eclips X4, Eclips X4 30°
2012-01
shall be pressed in.