Adjusting Of The Footrests - Vermeiren Eclips X4 Gebrauchsanweisung

3.8

Adjusting of the footrests

3.8.1 Length of the footrests
L L L L
CAUTION:
Risk of damage – Avoid that the footrests make any contact with the
ground. Keep a minimum distance from 60 mm above the ground.
Adjust the length of the footrests as follow (3 positions possible: steps 35 mm → holes
outside tube, 6 positions possible: steps 25 mm → inner tube):
1. Remove the screw
2. Adjust the length of the footrest to a comfortable length.
3. Tighten the screw
3.8.2 Depth of the footplate
Adjust the depth of the footplate as follow (in three different positions: steps 20 mm):
1. Remove the screws
2. Adjust the depth of the footrest to a comfortable position
Position 1: hole 2 and 4
Position 2: hole 3 and 5
Position 3: hole 4 and 6
3. Tighten the screws properly
A
3. Loosen the bolts
mechanism can slide over the guide
4. Pull the brake mechanism over the guide
the desired position.
5. Retighten the bolts
6. Check working of the brakes.
7. If necessary repeat the above steps until the
brakes are adjusted well.
.
properly.
.
(Fig B)
.
(Fig B)
Page 21
Eclips X4, Eclips X4 30°
2012-01
so the brake
.
.
(Fig A)
.
(Fig A)
to
B