Adjusting Of The Handgrips; Adjusting Of The Tip Cap - Vermeiren Eclips X4 kids 90 Gebrauchsanweisung

3.10 Adjusting of the handgrips

L
WARNING:
Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
L
WARNING:
Risk of tipping over - Make sure that the tubes of the handgrips are
positioned identically on both sides.

3.11 Adjusting of the tip cap

L
WARNING:
Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
A tip cap is mounted on the lower back frame that can be adjusted in its height depending on
the seat height of the wheelchair.
The tip cap can be placed in 2 different position with a difference of 15 mm.
If an anti-tipping is installed, it replaces the addition of the tip cap and can be used
accordingly.
With the model Eclips X4 kids 90° you can adjust
the height of the handgrips  in back tube .
1. Loosen the star knob .
2. Set the handgrips to the required height (6
different positions: steps of 30 mm.)
3. Retighten the star knob  again.
The back cushion is not adjustable in different
heights. The back height (BH: 300 mm, 350 mm,
400 mm) must be indicated when ordered.
1. Remove the screws Ⓑ.
2. Adjust the height of the tip cap to a
comfortable position.
Tube tip cap Ⓐ
Tip cap height
115 mm Hole 1 and 3
(Standard)
130 mm Hole 1 and 3
Table 3: Tip cap heights for wheelchair with
seat height of 420 mm
3. Tighten the screws properly Ⓑ.
Page 18
Eclips X4 kids 90°
2014-08
Tube frame Ⓒ
Hole 1 and 3
Hole 2 and 4
(Fig C)