Adjusting The Seat Depth - Vermeiren Forest Narrow Gebrauchsanweisung

Adjusting seat height (not for adjusting seat inclination)
1. Remove footrests, armrests and fold down backrest.
2. Remove the screws
3. Place the seat height in the desired position by mounting the connection plate
right hole of the plates
plate in detail A in the same position as the holes of connection plate
B.
4. Retighten the screws
5. Check that the seat frame is firmly fixated.
Adjusting seat angle
1. Remove footrest, armrests and fold down backrest.
2. Place something between the seat frame and lower frame, or let someone lift the seat
frame.
3. Remove the screws
4. Place the seat angle in the desired position.
5. Retighten the screws
6. Check that the seat frame is firmly fixated.

3.3.2 Adjusting the seat depth

L L L L
WARNING:
Risk of injury - Never change the seat depth when the user is sitting in
the wheelchair.
L L L L
WARNING:
Risk of injury - Check that the backrest plates
always set in the same seat depth position.
The Vermeiren Forest is adjustable in different seat depths over a range of 430 mm to 490
mm.
from the connection plates
mounted on the seat frame. Place the holes of connection
properly.
from the plates just below the seat frame.
properly.
The seat depth is adjusted in 4 positions (steps of 20
mm) by moving the backrest into different positions.
1. Loosen the two screws
frame.
2. Pull the backrest plates
frontwards until the desired position and until the
relevant holes lie above one another so that the
fixing screws
frame.
3. Hand-tighten the screws
you previously loosened.
Page 28
Forest, Forest Narrow
just below the seat frame.
on both sides are
on either side of the
more backwards or
can be inserted through the
back up with the nuts
2012-12
in the
in detail