Adjusting The Time; Adjusting The Unit Of Weight; Use; Switching On Your Scales / Measuring Your Weight - Silvercrest SDWH 180 A1 Bedienings- En Veiligheidsinstructies

Adjusting the time

The value (0:00) appears on the LC display
ter the insulation strip has been removed from the
batteries.
If you would like to adjust the time during normal
operation, press the SET button
The hour display will flash.
Press the button
adjust the hour.
Press the SET button
The minute display will flash.
Press the button
adjust the minutes.
Press the SET button

Adjusting the unit of weight

Note: The factory default setting for the scales as
supplied is "kg". If you would like to change to „lb"
or „st" proceed as follows:
Press the SET button
„0.0 kg" display.
Then, press the SET button
The kg unit will begin to flash.
By pressing the
you can select the desired unit of weight.
Note: If you select the „lb/st" unit of weight, the
height will be displayed in „feet/inches." If you
select the „kg" unit of weight, the height will be
displayed in „cm".

Use

Switching on your
scales / measuring your weight
Tip: Weigh yourself at the same time of day (pref-
erably in the morning) after visiting the toilet, with
an empty stomach and without clothing to ensure
that your results are comparable.
1
for 3 seconds.
8
or the button
5 7
to confirm your entry.
8
or the button
5 7
to confirm your entry.
8
until you reach the
8
for 3 seconds.
8
button within 2 seconds,
5
Place the scales down on a solid, flat, horizon-
tal surface.
af- Note: Do not place the scales on a carpet, as
this may influence the results. If necessary you
can place a board on the carpet and place the
scales upon this. A solid floor covering is required
in order to achieve correct weight measure-
ments.
You can attach the hand-held unit
to scales (see Fig. A) or have the option of
holding it in your hand (see Fig. B).
Optionally: You can also hang the hand-
held unit
4
to on the reverse side and therefore hang it to
11
the wall.
Important! The scales work via infrared
transmission. You must therefore ensure that
there is a direct connection between the infra-
red transmitter
red receiver
There should be no obstacles between the
scales and the hand-held unit
transmitter
2
should also not be covered.
Note: There is a limited range between the in-
frared transmitter
(max. 1.80 m vertically).
9
Distribute weight evenly on both legs when you
step onto the scales. The hour display disap-
pears.
If at all possible, stand on the same areas of
the platform each time and do not move. Mov-
ing during the weighing process can lead to
discrepancies in the results. The scales will start
to measure immediately. The measurement
result will be displayed on the LC display
When the displayed weight flashes thrice, the
measurement is complete.
Note: The scales are overloaded if the dis-
play shows "Err". Do not exceed the maximum
load capacity of 180 kg (396 lb / 28 st).
Step off the platform. The LC display
show the time once more.
Note: Do not use the scales in the vicinity of
electromagnetic fields. This could affect the
measurement results.
Initial use / Use
4
on a nail or screw using the slot
on the scales and the infra-
2
on the hand-held unit
9
. The infrared
4
and the infrared receiver
and the infrared receiver
2
to the
.
4
9
.
1
will
1
GB/IE 23