Fitting The Force Measuring Device Using The Robot Adapter Cpk; Set Up The Base Frame And Align - HellermannTyton Autotool 2000 CPK Montageanleitung

f Close the cover and tighten the fixing screw
2
; The AT2000 CPK is fitted securely in the grip mount.
1
5 3 Fitting the force measuring device using the
Robot adapter CPK

5 3 1 Set up the base frame and align

3
f Position the base frame
surface.
f To align the base frame, unfasten the hexagon nuts
and screw the feet inwards or outwards.
2
f Check alignment using the spirit level.
f Tighten the hexagon nuts
Assembly Instructions • Force Measurement Device CPK • 04/2018 • v03 • 102-01002
.
3
2
on a level and clean work
3
.
1
5 3 2 Fitting the manual force measuring device
1
6
5
1
f By hand, carefully screw the band mount
drawbar .
6
f Screw the drawbar
unit .
1
; The band mount
f When fitting MI&T manual force measuring devices,
place the two spacers
f Insert the four screws
base plate into the manual measuring device
3
1
f Tighten the manual force measuring device
Installation
onto the
5
into the manual force measuring
6
is horizontal.
5
onto the base plate
2
from the bottom through the
4
1
2
3
4
.
3
.
1
.
9