Notes For The User; Information About The Product; Warranty; Contact Data - HellermannTyton Autotool 2000 CPK Montageanleitung

1

Notes for the user

These instructions are very important for the correct use of
the device. They contain important information and safety
instructions that will enable you to install the product
properly and utilise it correctly and economically for its
intended use.
1 1

Information about the product

Product designation: Force Measurement Device CPK
Item number: 106-29010 / 106-29011
1 2

Warranty

The warranty is in accordance with statutory requirements.
Warranty entitlement applies only in the country in which
the products were originally purchased. Batteries, fuses and
light sources are not covered by the warranty.
1 3

Contact data

The manufacturer of the product described in these
instructions is:
HellermannTyton GmbH
Grosser Moorweg 45
D-25436 Tornesch, Germany
Tel. +49 4122 701-0
www.HellermannTyton.de
info@HellermannTyton.de
1 4

Information about these Assembly Instructions

Last update: 05.06.2018
1 5 Copyright and intellectual property rights
The manufacturer retains the copyright to these instructions.
Under no circumstances may these instructions be
reproduced or electronically processed, replicated or
disseminated, in whole or in part, without the prior written
consent of HellermannTyton GmbH (hereinafter referred to
as HellermannTyton).
Any breach or infringement of these stipulations will result in
liability for damages.
1 6 Keeping and dissemination of these
instructions
These instructions must be kept in the immediate vicinity of
the workplace and must be available at all times to all
operating personnel. The operating company shall inform
the operating personnel of the location of these instructions.
The operating company shall obtain replacement from the
manufacturer if these instructions are, become or are
rendered no longer easily legible.
If the Force Measurement Device CPK is acquired by or sold
on to a third party the following documents must be handed
over to the new owner:
• These instructions
• Documents relating to repair work
• Logs of repair work undertaken
Assembly Instructions • Force Measurement Device CPK • 04/2018 • v03 • 102-01002
1 7

Target group of these instructions

These instructions must be read and complied with by every
person charged with any of the following tasks:
• Installation
• Operation
• Maintenance
• Repair
• Fault rectification
1 8

General information

All accompanying drawings are exempt from the
modification service.
1 9

Conventions adopted in these instructions

1 9 1 Classification of the precautionary notices
Precautionary notices in these instructions draw attention to
hazards associated with use of the device and indicate how
they can be avoided.
Non-compliance of any nature whatsoever can lead to
accidents with fatal consequences, injury or damage to
property.
The precautionary notices are subdivided into three groups
according to the severity of the potential hazard:
DANGER
Texts accompanied by the signal word "DANGER" indicate
hazardous situations which, in the event of non-compliance
with the appropriate precautions, will cause death or severe
injury.
WARNING
Texts accompanied by the signal word "WARNING" indicate
hazardous situations which, in the event of non-compliance
with the appropriate precautions, can cause death or serious
injury.
CAUTION
Texts accompanied by the signal word "CAUTION" indicate
hazardous situations which, in the event of non-compliance
with the appropriate precautions, can cause slight injury.

1 9 2 Other notational conventions

f Indicates an instruction
• Indicates an item in a bullet list
; Indicates the result of an action
à This text highlight is used for cross-references.
NOTE
Texts accompanied by the signal word "NOTE" indicate
situations which, in the event of non-compliance with the
appropriate precautions, can cause damage to the
AT2000 CPK or the Force Measurement Device CPK.
Texts accompanied by this symbol contain information about
environmental protection.
Notes for the user
4